泡沫复合驱污水配注聚合物溶液粘度损失原因及对策
DOI:
作者:
作者单位:

作者简介:

袁斌,男,高级工程师,从事采油和油田地面建设工作。联系电话:18999998679,E-mail:xjyuanbin@126.com。

通讯作者:

基金项目:


Analysis and treatments of factors for viscosity loss of polymer solution with sewage in foam flooding
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
    摘要:

    为了确定泡沫复合驱污水配注聚合物溶液粘度损失严重的主要原因,寻找保持粘度稳定的有效措施,分析了金属阳离子、溶解氧、硫化物、化学需氧量、硫酸盐还原菌和泡沫剂及破乳剂对聚合物溶液粘度损失的影响程度,确定了污水中的还原性物质是导致聚合物溶液粘度损失的主要因素。在此基础上,研究了埕东油田泡沫复合驱污水配注聚合物溶液粘度的稳定方法,提出了适宜高效的曝气生物氧化工艺技术。利用曝气氧化方法,将通过硫化细菌和硝酸盐还原菌这2类菌株联合生化处理的污水用于配制聚合物溶液,可使聚合物溶液的粘度达到35 mPa?s并趋于稳定。

    Abstract:

    The effects of various factors on viscosity loss of polymer solution are investigated to highlight the main issue of serious loss for viscosity during foam flooding as well as to find the effective preserving measurements. The results showed that the reducing substances in the wastewater such as sulfides, Fe2+, SRB, and COD are the main reasons affecting the viscosity loss of polymer solution. On this basis, one kind of preserving method for viscosity loss of polymer solution in Chengdong foam flooding is pointed out by aerobic biological oxidation. The viscosity of polymer solution prepared with the wastewater which is aerobically treated by sulfur-oxidizing bacteria SOB and denitrifying bacteria DNB can reach more than 30 mPa?s.

    参考文献
    相似文献
    引证文献
引用本文

袁斌,韩霞.泡沫复合驱污水配注聚合物溶液粘度损失原因及对策[J].油气地质与采收率,2013,20(2):83~86

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
历史
  • 收稿日期:
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期: 2015-09-20
×
《油气地质与采收率》
《油气地质与采收率》启动新投稿网站的公告